3
(a) BIOS with RAID function: Copy the /Silicon_Image/SIL3114RAID/Win_Drv driver from the
Driver CD to the diskette.
(b) BIOS without RAID function: Copy the /Silicon_Image/SIL3114/Win_drv driver from the
Driver CD to the diskette.
Step 2: Make sure the SATA hard drive is properly connected to the Serial ATA host controller card and the
card is properly installed into a PCI slot.
Step 3: If your Windows NT/2000/XP Installation CD is bootable, simply put the CD into the CDROM
drive and startup your system to begin installation. If your Windows NT/2000/XP Installation CD is
not bootable, you must use the Windows NT/2000/XP bootable diskette to boot up first before
commencing installation.
Step 4: Press “F6” for third party SCSI or driver installation at the beginning of the text mode installation.
Insert the 1.44MB floppy diskette into the floppy drive. Press “s” when setup asks if you want to
specify an additional device.
(a) BIOS with RAID function: Select “Silicon Image SIL3114 SATARaid Controller”.
(b) BIOS without RAID function: Select “Silicon Image SIL3114 SATALink Controller”.
Step 5: Press “Enter” to continue on with text mode setup.
Step 6: Follow the setup instructions to complete installing Windows NT/2000/XP.
Installing drivers to an existing SATA hard drive with Windows NT 4.0:
If you are already using a SATA hard drive with Windows N.T in your system and you want to connect this
SATA hard drive to the Serial ATA host controller card as the default bootable drive, you must follow these
procedures.
Step 1: Make sure the SATA hard drive is still connected to the default SATA controller. Make sure the
Serial ATA host controller card is properly installed into your system and there is no SATA device
connected to the card.
Step 2: Start Windows NT.
Step 3: After Windows NT boot up, open “Control Panel”, and then enter “SCSI Adapters”.
Step 4: Insert the Driver CD into the CDROM drive and select “Drivers” tab and click “Add”.
Step 5: Select “Have Disk” and click on “Browse” button.
(1) Select CDROM drive.
(2) Select folder “Silicon_Image”.
(3a) BIOS with RAID function: Select folder “SIL3114RAID” or
(3b) BIOS without RAID function: Select folder “SIL3114.
(4) Select folder “Win_Drv”.
Step 6: (1a) BIOS with RAID function: Select “Silicon Image SIL3114 SATARaid Controller”
(1b) BIOS without RAID function: Select “Silicon Image SIL3114 SATALink Controller”
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals